MacDon M100 SP Operators Manual - Manual (Page 97)

HEADER OPERATION – A SERIES
169304
95
Rev. C
6.6.4 Reel Speed
6.6.4.1 A30-S and A30-D Headers
The reel speed is fixed to the auger speed and
to the knife speed. Both can be changed by
installing alternate drive sprockets. Refer to
your Auger Header Operator’s Manual.
6.6.4.2 A40-D Header
The A40-D auger header features a hydraulic
direct drive reel with operating speed range of
51 to 76 rpm and is controlled with switches on
the CDM, and on the GSL at the operator’s
station. The hydraulic flows for the reel and
auger are interconnected so that the auger and
reel speeds are controlled using a combination
of the CDM switches and the GSL switches.
ENGAGE HEADER
ON CDM PRESS
FAST
DISPLAY SHOWS
##.# AUGER SPEED
DONE
SPEED
99.0?
NO
YES
PRESS DISPLAY SELECTOR
FOR ##.# AUGER SPEED
HEADER INDEX
SWITCH - OFF
##.# = 0.00 – 9.9
00.0 = 150 rpm
* 9.9 = 320 rpm
* Auger Speed Not To Exceed 320 rpm.
ON GSL PRESS
FAST OR SLOW
DISPLAY SHOWS
##.## REEL SPEED
SPEED
OK?
NO
YES
PRESS DISPLAY SELECTOR
FOR ##.## REEL SPEED
SPEED
OK?
NO
YES
##.## = RPM
DISPLAY
SELECTOR
DISPLAY
HEADER INDEX
FAST
SLOW
AUGER & REEL SPEED
SLOW
FAST
REEL SPEED