MacDon M100 SP Operators Manual - Manual (Page 79)

HEADER OPERATION – D SERIES
169304
77
Rev. C
6.5 D SERIES HEADER OPERATION
6.5.1 Header Attachments
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight box attached to
windrower, ensure that float engagement
pin is installed in storage location (A), and
not installed at hole location (B).
a. If not installed, attach draper header boots
(supplied with header) to windrower lift linkage
as follows:
1. Remove hairpin and remove pin (C) from
boot (D).
2. Locate boot (D) on lift linkage (E) and
reinstall pin (C). Pin may be installed from
either side of boot.
3. Secure pin (A) with hairpin.
4. Repeat for opposite side.
b. Remove hairpin on pins (F) and remove pins
from header legs.
CAUTION
Check to be sure all bystanders have cleared
the area.
(continued next page)
C
D
D
E
C
F
B
A