MacDon M100 SP Operators Manual - Manual (Page 156)

MAINTENANCE/SERVICE
169304
154
Rev. C
57.9.2 Changing Hydraulic Oil
NOTE
Change hydraulic oil every 2000 hours.
a. Stop engine and remove key.
b. Open engine compartment hood to highest
position.
c. Place a suitable container (at least 20 gal. US
(75 liters)) under drain to collect oil.
d. Remove drain plug from bottom of hydraulic oil
reservoir and allow oil to drain.
e. Clean off any metal debris that my have
accumulated on magnetic drain plug. Replace
and tighten drain plug.
f. Add oil to the tank to the required level through
the filler pipe. Refer to previous section.
57.9.3 Hydraulic Oil Cooler
The hydraulic oil cooler is located inside the
cooling box behind the radiator. It should be
cleaned daily with compressed air. Refer to
Section 7.9.2 Cooling Box Maintenance.
57.9.4 Hydraulic Oil Filters
NOTE
Change hydraulic oil filters after the first
50 hours of operation and every 500 hours
thereafter. Filter (A) part #112420 and
filter (B) part #151975 can be obtained
from your dealer.
The hydraulic system contains two filters.
Change hydraulic oil filters as follows:
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Stop engine and remove key.
b. Clean around heads of the filters (A) and (B).
c. Unscrew the filters with a filter wrench.
d. Clean the gasket surface of the filter heads.
e. Fill new filters with clean oil and apply a thin film
of clean oil to the filter gaskets.
f. Screw the new filters onto the mount until the
gasket contacts the filter head.
g. Tighten filters an additional ½ turn by hand.
IMPORTANT
Do not use a filter wrench to install oil
filter. Over-tightening can damage gasket
and filter.
A
B