MacDon M100 SP Operators Manual - Manual (Page 149)

MAINTENANCE/SERVICE
169304
147
Rev. C
c. Pinch the wire retainer (J) and lift away from
hooks.
d. Remove bulb (K) from body and pull wire from
connector (L) .
IMPORTANT
Do not touch the glass of the halogen bulb
as the oils or other chemicals from your
skin will cause the bulb to fail prematurely.
e. Match slots on new bulb (K) with lugs (O) in
optical unit and insert bulb into unit.
f. Secure bulb with wire retainer (J).
g. Push wire into connector (L).
IMPORTANT
For proper lighting pattern, be sure lights
are installed right side up.
h. Position light into light receptacle, ensuring top
is up, and secure with bezel (B) and screws (A).
57.8.5.1 Red Tail Lights
a. Shutdown engine and remove the key. Turn off
the lights.
b. Remove two screws (C) from light (D) and
remove light.
c. Remove connector from light.
d. Connect wiring harness to new light and install
light with screws (C).
D
C
J
K
L
O
A
B