beautypg.com

Warning – MacDon M100 SP Operators Manual User Manual

Page 129

background image

MAINTENANCE/SERVICE

169304

127

Rev. C

57.6.5.5 System Priming

Controlled venting of air is provided at the
injection pump through the fuel drain manifold.
Small amounts of air introduced by changing
filters or injection pump supply line will be
vented automatically, if the fuel filters are
changed in accordance with instructions.

WARNING

The fuel pump high-pressure fuel lines and
fuel rail contain extremely high pressure fuel.
Never loosen any fittings. Personal injury
and property damage can result.

IMPORTANT

Bleeding the fuel system is not
recommended nor required.

a. Manual priming may be required if:

• The fuel filter is not filled prior to installation.
• Injection pump is replaced.
• High-pressure fuel lines are replaced.
• Engine is run until fuel tank is empty.

b. Prime the fuel system as follows:

1. Stop the engine and remove the key.

2. Open engine compartment hood to lowest

position.

3. Turn the priming knob (A) counterclockwise

to unlock the plunger on the primary filter
head.

4. Pump approximately 120 times to pressurize

the fuel system.

5. Lock the plunger by turning knob (A)

clockwise until snug.

A