MacDon M100 SP Operators Manual - Manual (Page 82)

HEADER OPERATION – D SERIES
169304
80
Rev. C
p. Connect reel hydraulics (R) at RH side of
windrower. Refer to the Draper Header
Operator’s Manual.
6.5.2 Header Detachment
a. Raise the header fully with the header up switch
on the GSL. Stop engine and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
b. Engage lift cylinder stops on both lift cylinders.
Refer to Section 6.4.1 Header Lift Cylinder
Stops.
c. Remove pin (A) from header leg on both sides.
d. Lower header stand (B) by pulling spring loaded
pin (C). Release pin to lock stand.
(continued next page)
B
C
A
HEADER UP
HEADER DOWN
REEL HYDRAULICS
R