Display warnings and alarms – engine/transmission – MacDon M100 SP Operators Manual User Manual
Page 39
OPERATOR’S STATION
169304
37
Rev. C
5.18.4.2 Display Warnings
DISPLAY WARNINGS AND ALARMS – ENGINE/TRANSMISSION
DISPLAY
FLAS
H
ING
ALARM TONE
DESCRIPTION
ENGINE OIL PRESSURE
Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Engine Oil Pressure.
Accompanied By Warning Lights.
ENGINE
TEMPERATURE
Ongoing Intermittent Moderate
Tone Until Temperature Is Below
215F. (102C.)
Engine Temperature Over 230F.
(110C.).
Accompanied By Warning Lights.
##.# LOW VOLTS
Single Loud Tone For 10 Seconds. Voltage Below 11.5.
##.# HIGH VOLTS
Single Loud Tone For 10 Seconds. Voltage Above 16.
IN PARK
One Short Beep
Steering Wheel Centered, And
Brakes Are Engaged.
PLACE GSL INTO “N”
Beeps At 2 Per Second Until
Corrected.
Interlock Switch Not Closed With
Key On/Engine Off.
TRANS OIL PRESS
Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Transmission Charge Oil
Pressure.
TRANS OIL TEMP
Ongoing Intermittent Moderate
Tone Until Temperature Is Below
Acceptable Level.
Transmission Oil Temperature
Above 221F (105C).
DISPLAY WARNINGS
Informs Operator of Abnormal
Windrower Conditions
See Table Below