MacDon M100 SP Operators Manual - Manual (Page 84)

HEADER OPERATION – D SERIES
169304
82
Rev. C
HYDRAULIC LINK – OPTION
1. Start engine and activate header tilt cylinder
switch on GSL to release load on center link
cylinder.
2. Disconnect center link by lifting release (M)
and lift hook (N) off header.
k. Slowly back windrower away from header.
NOTE
If hay conditioner is installed, watch
clearances on both sides.
l. Reinstall pin (A) into header leg and secure with
hairpin.
6.5.3 Header Position Adjustments
Refer to Section 6.4 HEADER OPERATION for
procedures for controlling header height, header
tilt, and float.
6.5.4 Reel Fore-Aft Position (Optional)
Press and hold the switch for the desired fore or
aft movement of the reel.
6.5.5 Reel Height
Press and hold the switch for the desired up or
down movement of the reel.
A
M
N
REEL AFT
REEL FORWARD
REEL UP
REEL DOWN