MacDon M100 SP Operators Manual - Manual (Page 170)

MAINTENANCE/SERVICE
169304
168
Rev. C
57.11.2 Interval Maintenance
INTERVAL SERVICE
FIRST USE Refer To Break-In Inspection On Previous Page.
ANNUALLY *
1. Change Fuel Tank Vent Line Filter.
2. Check Battery Fluid Level.
3. Check Battery Charge.
4. Check Anti-Freeze Concentration.
5. Cycle A/C Blower Switch To Distribute Refrigerant Oil.
6. Check Safety Systems (or 500 hours whichever occurs first).
END OF
SEASON
Refer To Section 6.3.9 Storage.
10 HOURS OR
DAILY
1. Check Tire Inflation.
2. Check Engine Oil Level.
3. Check Engine Coolant Level At Reserve Tank.
4. Clean Radiator, Hydraulic Oil Cooler, Charge Air Cooler, And A/C Condenser.
5. Check Hydraulic Oil Level.
6. Drain Fuel Filter Water Trap.
7. Fill Fuel Tank.
8. Check Hydraulic Hoses And Lines For Leaks.
50 HOURS
1. Grease Caster Pivots.
2. Grease Walking Beam Center Pivot.
3. Grease Top Lift Link Pivots.
4. Grease Forked Caster Spindle Bearings.
5. Clean Cab Fresh Air Intake Filter.
100 HOURS OR
ANNUALLY *
1. Clean Cab Air Return Filter.
200 HOURS OR
ANNUALLY *
1. Check Drive Wheel Lubricant Level.
2. Grease Formed Caster Wheel Hub Bearings.
3. Check Wheel Nut Torque.
250 HOURS OR
3 MONTHS
1. Change Engine Oil And Filter.
2. Change Engine Air Cleaner Primary Filter Element (CDM displays
ENGINE AIR
FILTER).
500 HOURS
1. Change Fuel Filters.
2. Change Hydraulic Oil Filters.
3. Check Engine Valve Tappet Clearance.
1000 HOURS
1. Change Drive Wheel Lubricant.
2. Check Engine Valve Tappet Clearance.
2000 HOURS
1. Change Hydraulic Oil.
2. Perform General Engine Inspection.
3. Change Engine Coolant.
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING
SEASON.