MacDon M100 SP Operators Manual - Manual (Page 32)

OPERATOR’S STATION
169304
30
Rev. C
5.18 CAB DISPLAY MODULE (CDM)
5.18.1 Engine and Windrower Functions
5.18.2 Header Functions
HAZARD WARNING LIGHTS SWITCH
Activates Hazard Warning Lights
Cancels Turn Signal
TURN SIGNAL SWITCHES
Activates Turn Signals On Windrower and
Header
Push-On/Push-Off
GROUND SPEED
mph or kph
ENGINE RPM
DISPLAY
Engine/Windrower Functions
IGNITION SWITCH POSITIONS
Accessory/Stop/Run/Start
ENGINE WARNING LIGHTS
Engine Pre-Heat/Water In
Fuel/Do not Operate/Stop Engine
SELECT SWITCH
Allows Operator To Select Display Item
On Lower Line.
See Table
Push To Select
DISPLAY
Header Functions
HEADER INDEX SWITCH - OPTION
Links Reel and Conveyor Speed to Ground Speed
Push-On/Push-Off
Illuminates In On Position
SELECT SWITCH
Allows Operator To Select Display Item
Bottom Line - See Table
Push To Select
RETURN TO CUT HEIGHT SWITCH
Allows Cutting Height Pre-Set
Push-On/Push-Off
Illuminates In On Position
NOTE
HEADER MUST BE ENGAGED.
DRAPER SPEED CONTROL - DRAPER HEADER
Controls Draper Speed
Push Upper Switch to Increase
Push Lower Switch to Decrease
With Optional Module
Controls Draper Speed INDEX with INDEX SWITCH on.
Controls Draper SPEED with INDEX SWITCH off.
REEL/AUGER SPEED CONTROLS - AUGER HEADER
Controls Auger And Reel Speed.
See Section 6.6 For Detailed Procedures.