MacDon M100 SP Operators Manual - Manual (Page 182)

OPTIONS
169304
180
Rev. C
59 OPTIONS
59.1 REEL DRIVE & LIFT PLUMBING
Reel drive and lift plumbing for draper headers
on windrowers that are shipped from the factory
in auger header configuration. Installation
instructions are included.
59.2 WINDROWER HYDRAULIC
COMPLETION FOR DRAPER
HEADER REEL FORE/AFT
Allows reel fore/aft hydraulic adjustment for
draper headers on windrowers that are shipped
from the factory in auger header configuration.
Kit includes valve for selection of reel fore/aft or
double windrow attachment functions.
Installation instructions are included.
59.3 BOOSTER SPRING KIT
Available for headers over 6000 lb (2724 kg).
Installation instructions are included.
59.4 INTERNAL BOOSTER SPRING KIT
Internal spring for right side lift linkage to
improve float capacity. Standard equipment on
left side. Installation instructions are included.
59.5 LIGHT HEADER FLOTATION KIT
Available for headers that do not require as
much spring tension for float. Installation
instructions are included.
59.6 AM-FM RADIO
Available for installation into pre-wired cab.
Speakers are factory installed.
Refer to M100 Self-Propelled Windrower
Unloading and Assembly Instructions supplied
with your windrower for installation details.
59.7 HYDRAULIC CENTER LINK
The hydraulic center link allows the operator to
adjust the header angle from the cab.
Installation instructions are included.
59.8 FAN AIR BAFFLE KIT
Provides a baffle to reduce windrow disturbance
by air exiting the engine cooling fan.
59.9 TRAINING SEAT
A wall mounted fold-up training seat complete
with seat belt is available to assist in training a
new operator. Installation instructions are
included.
59.10 KNIFE SPEED, REEL SPEED
INDEX, AND TILT SENSOR
MODULE
To allow the electronic monitoring of header
knife speed, reel speed and header angle. Also
enables the indexing of reel speed to ground
speed. Installation instructions are included.
59.11 ANTI-SHIMMY KIT FOR CASTERS
Prevents caster wheel shimmy when traveling at
road speed.
59.12 SWATH ROLLER
If a swath roller is desired for canola or other
similar crops, an axle mounted design is
recommended. Windrower can be fitted with
hydraulic lift version of swath rollers featuring in
console controls.
59.13 WARNING BEACONS
Two roof mounted rotating warning beacons are
available for installation into pre-wired cab. The
beacons are standard equipment for export
windrowers and optional for North America.
Installation instructions are included.
59.14 AUTO-STEER
A MacDon approved auto-steer system is
available for your windrower. Contact your
dealer for further information.
Cabs have been prepared with “access routing
knock outs” to enable easy wiring harness
installation and display mounting. The GSL has
been pre-wired with an auto-steer engage
switch.
59.15 ENGINE BLOCK HEATER
Contact your nearest Cummins Engine
Distributor and provide your engine model and
serial numbers to ensure the proper heater is
supplied.
(continued next page)