MacDon M100 SP Operators Manual - Manual (Page 67)

WINDROWER OPERATION
169304
65
Rev. C
6.3.8.2.2 From Transport Mode To Field
Operation
a. Shutdown windrower and remove key.
b. Disconnect windrower harness (A) from towing
harness receptacle (B) in LH float spring tower.
c. Disconnect electrical harness (C) from
windrower and store harness on tow-bar.
d. Undo lock (D) and remove safety chain (E) from
drawbar and remove clevis pin (F).
e. Move tow-bar off drawbar.
f. At rear of windrower, remove pins (G), lift
drawbar support (H) to horizontal position, and
re-install pins as shown.
g. Alternate drawbar (J) is used for attaching tow
behind swath roller.
IMPORTANT
Do not use alternate drawbar for any other
purpose.
h. Disassemble tow-bar and store on header. See
Header Operator’s Manual.
(continued next page)
C
A
B
G
H
H
G
J
E
F
D