MacDon M100 SP Operators Manual - Manual (Page 40)

OPERATOR’S STATION
169304
38
Rev. C
DISPLAY WARNINGS AND ALARMS - WINDROWER
DISPLAY
FLAS
H
ING
ALARM TONE DESCRIPTION
BRAKE OFF
Engine Running, Brake Solenoid Not
Activated.
BRAKE SW FAILURE
Ignition On/Engine Not Running,
Brake Switch And Relay Closed.
CENTER STEERING Beeps At 2 Per Second
Interlock Switch Not Closed With
Key On/Engine Off.
DISENGAGE HEADER 
None
Header Switch Is In On Position
When Ignition Switch Turned On.
HEADER DISENGAGED None Normal
HEADER OIL PRESS 
Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Header Charge Oil Pressure.
Header Shuts Down Automatically.
Header On Switch Must Be Moved
To Off Position And Then To On
Position To Restart The Header.
HYDRAULIC FILTER 
Single Loud Tone For 10 Seconds.
Repeats Every 15 Minutes Until
Condition Is Corrected.
Excessive Pressure Drop Across
Hydraulic Oil Filter.
KNIFE OVERLOAD 
Ongoing Intermittent Moderate
Tone Until Condition Is Corrected. Machine Overload. Knife Speed
Drops Below Programmed Value.
LOW HYDRAULIC OIL 
Continuous Loud Tone For 5
Seconds. If Condition Not
Rectified, Single Loud Tone Every
5 Minutes
Low Hydraulic Oil Level. Header
Shuts Down Automatically If
Engaged. Header On Switch Must
Be Moved To OFF Position And
Then To ON Position To Restart The
Header.
NO HEADER None Header Is Not Detected.
NO OPERATOR Continuous Tone.
Operator Not Detected In Seat With
Header Engaged Or Out Of Neutral
Detent. Engine Shutdown After 5
Seconds
NOT IN PARK 
Short Beep With Each Flash
Interlock Switch Not Closed With
Key On/Engine Off.