MacDon M100 SP Operators Manual - Manual (Page 102)

MAINTENANCE/SERVICE
169304
100
Rev. C
7.3.2 Recommended Torques
• Tighten all bolts to the torques specified in
chart unless otherwise noted throughout this
manual.
• Check tightness of bolts periodically, using
bolt torque chart as a guide.
• Replace hardware with the same strength
bolt.
• Torque figures are valid for non-greased or
non-oiled threads and heads unless
otherwise specified. Do not grease or oil
bolts or capscrews unless specified in this
manual. When using locking elements,
increase torque values by 5%.
7.3.2.1 SAE Bolts
BOLT
DIA. "A"
in.
NC BOLT TORQUE*
SAE 5 SAE 8
lbf·ft N·m lbf·ft N·m
8 1/4 9 9 10 12 11 11 12 15
13 5/1
6
14 18 15 24 16 25 17 34
18 3/8 19 32 20 43 21 41 22 56
23 7/1
6
24 50 25 68 26 70 27 95
28 1/2 29 75 30 10
2
31 10
5
32 14
2
33 9/1
6
34 11
0
35 14
9
36 14
9
37 20
2
38 5/8 39 15
0
40 20
3
41 20
0
42 27
1
43 3/4 44 26 45 35 46 36
5
47 49
5
48 7/8 49 42
0
50 56
9
51 60
0
52 81
3
53 1 54 64
0
55 86
7
56 89
0
57 12
0
* Torque categories for bolts and capscrews are identified by their
head markings.
57.1.1.1 Metric Bolts
BOLT
DIA.
"A"
NC BOLT TORQUE*
8.8 10.9
lbf·ft N·m lbf·ft N·m
M3 0.4 0.5 1.3 1.8
M4 2.2 3 3.3 4.5
M5 4 6 7 9
M6 7 10 11 15
M8 18 25 26 35
M10 37 50 52 70
M12 66 90 92 125
M14 103 140 148 200
M16 166 225 229 310
M20 321 435 450 610
M24 553 750 774 1050
M30 1103 1495 1550 2100
M36 1917 2600 2710 3675
* Torque categories for bolts and capscrews are identified by their
head markings.
SAE-5 SAE-8