MacDon M100 SP Operators Manual - Manual (Page 78)

HEADER OPERATION
169304
76
Rev. C
2. If the header is below the pre-set height,
press and hold the HEADER UP switch to
raise the header. Release switch to stop
header. Alarm will sound when header rises
past the pre-set height.
3. If the header angle is changed, double click
(two clicks within 0.5 seconds) the HEADER
TILT UP or HEADER TILT DOWN switch
and the header will return to the pre-set
angle.
NOTE
If the header cannot return to the pre-set
height or angle within 30 seconds, the
RETURN TO CUT feature will deactivate
to prevent the hydraulic oil from
overheating. Push the RETURN TO CUT
switch to reactivate.
6.4.5.2 Auto-Raise Height
a. Program the AUTO RAISE HEIGHT feature as
follows:
1. RETURN TO CUT switch can be off or on.
2. PROGRAM and SELECT on CDM to enter
programming mode.
3. Press SELECT. TRACTOR SETUP? is
displayed on upper line.
4. Press , then SELECT. SET KNIFE
SPEED? is displayed.
5. Press SELECT until AUTO RAISE HEIGHT
is displayed.
6. Press or to change value on
lower line. Range is 0.0 to 10.0 where 10.0
is fully raised.
7. Press PROGRAM to exit programming
mode when finished entering desired values.
b. Use the AUTO RAISE HEIGHT feature as
follows:
IMPORTANT
The windrower must be running with the
header engaged at the cutting height and
the RETURN TO CUT switch activated.
1. Double click HEADER UP switch on the
GSL to raise the header to the AUTO RAISE
HEIGHT set point.
NOTE
If HEADER UP is pressed while header is
being raised, AUTO RAISE HEIGHT is
temporarily disabled and header will
maintain current height.
2. Momentarily press the HEADER DOWN
switch on the GSL to return the header to
the pre-set cutting height.
HEADER DOWN
DISPLAY
HEADER UP
PROGRAM
SELECT
RETURN TO
CUT