Lenze i700 Manual - Manual (Page 71)

Mechanical installation 5
l
71 EDS700ACBA EN 4.0
Safety instructions for the installation according to UL
Original − English
J
Warnings!
ƒ The device should be mounted in an overall enclosure with proper spacings
being maintained.
ƒ The terminals are suitable for factory and field wiring connection when the
suitability of the intended mating connection has been determined.
ƒ All Cold Plate devices E70ACPxC... and E70ACMxC... are intended to be
mounted with adequate heat sink assemblies in the end use.
ƒ In Order to determine the acceptability of these assemblies , a temperature
test shall be considered in the end use. The temperature on the heat sinks
shall not exceed the values listed in Tab. 5−1.