beautypg.com

Electrical installation, Stop – Lenze i700 Manual User Manual

Page 100

background image

Electrical installation

Measures when drive is used in IT systems

6

l

100

EDS700ACBA EN 4.0

(

Stop!

Only operate the controllers with the mains chokes assigned.
Operation with mains filters or RFI filters by Lenze is not permitted, as these
modules contain components that are interconnected against PE. By this the
protective design of the IT system would be cancelled out. The components are
destroyed in the case of an earth fault.
Protect the IT system against earth fault at the controller.
Due to physical conditions, an earth fault on the motor side at the controller
can interfere with or damage other devices on the same IT system. Therefore
appropriate measures have to be implemented, by means of which the earth
fault is detected and which disconnect the controller from the mains.

Permissible supply forms and electrical supply conditions

Mains

Operation of the controllers

Comments

With an isolated neutral
point (IT systems)

Permissible if an earth fault is detected
and eliminated by suitable mechanisms
as soon as possible.

l

An earth fault on the motor side with
a switching frequency of 4 kHz or
8 kHz can cause a safety shutdown of
the device.

l

An earth fault on the motor side at
16 kHz presents an impermissible
load for the controller.

Permissible supply forms and electrical supply conditions

Mains

Operation of the controllers

Notes

With isolated star point (IT
systems)

Possible, if the controller is protected in
the event of an earth fault in the
supplying mains.

l

Possible, if appropriate earth fault
detections are available and

l

the controller is immediately
disconnected from the mains.

Safe operation in the event of an earth
fault at the inverter output cannot be
guaranteed.

Installation of the CE−typical drive system

For the installation of drives on IT systems, the same conditions apply as for the installation
on systems with an earthed neutral point.

According to the binding EMC product standard EN61800−3, no limit values are defined for
IT systems for noise emission in the high−frequency range.