Lenze i700 Manual - Manual (Page 123)

Commissioning
Before switching on
8
l
123 EDS700ACBA EN 4.0
8 Commissioning
)
Note!
ƒ Please observe the general safety instructions (
¶ 13).
ƒ Please observe the notes regarding residual hazards (
¶ 18).
8.1 Before switching on
Prevent injury to persons and damage to property by checking the following before
switching on the mains voltage.
Check
ƒ the wiring for completeness.
ƒ for the absence of short circuits and/or earth faults.
ƒ for the correct covering of the DC−bus wiring.
ƒ the "EMERGENCY OFF" function of the entire system.
ƒ the motor circuit configuration (star/delta). It must be adapted to the output
voltage of the controller.
ƒ the in−phase connection of the motor (direction of rotation).
ƒ whether the drive mechanically can be disconnected from the machine for
commissioning.
}
Danger!
High hazard potential during commissioning
Incorrect settings can cause unexpected and dangerous movements of the
motor and the equipment.
Possible consequences:
ƒ Damage to material assets
ƒ Injury to persons
Protective measures:
ƒ Clear hazard area
ƒ Observe safety instructions and safety distances
8.2 Quick commissioning
Quick commissioning is described in
ƒ the "Controller−based automation, EtherCAT" communication manual,
– the chapter "Commissioning of i700 servo inverter".