Lenze i700 Manual - Manual (Page 25)

Technical data
General data and operating conditions
4
l
25 EDS700ACBA EN 4.0
4 Technical data
4.1 General data and operating conditions
Conformity and approval
Conformity
CE 2006/95/EC Low−Voltage Directive
2004/108/EC EMC Directive
Machinery Directive 2006/42/EC Logic unit to ensure safety functions
(safety component acc. to Machinery Directive)
EAC TP TC 004/2011
(TR CU 004/2011) On safety of low voltage
equipment Eurasian Conformity
TR CU: Technical
Regulation of Customs
Union
TP TC 020/2011
(TR CU 020/2011) Electromagnetic compatibility of
technical means
Approval
C
UL
US
UL 508C
CSA 22.2 No. 14 E70ACxSE... Industrial Control
Equipment, Lenze File
No. 132659
C
UR
US
E70ACxSC...
E70ACxSD...
Protection of persons and devices
Enclosure EN 60529 IP 20 Specification
l applies to the fully
assembled state ready
for use
l does not apply to the
wire range of the
terminals
UL Protection against contact in
accordance with Open Type
EN 60529 Mounting type "push−through technique", heatsink side:
l IP54
Insulation resistance EN 61800−5−1 < 2000 m amsl: overvoltage category III
> 2000 m amsl: overvoltage category II
Insulation of control
circuits EN 61800−5−1 Safe mains isolation through double/reinforced insulation
(
^ 6.1.1):
l Touch probe inputs
l Safety system inputs
l Encoder feedback ( ^ 54)
Short−circuit strength EN 61800−5−1 l Motor connection: limited, controller is inhibited, error
acknowledgement is required
l Brake control: limited, error acknowledgement is required
l Control electronics and holding brake supply connections:
not short−circuit−proof
Protective measures
integrated for l Short circuit
l Earth fault
l Overvoltage
l Motor overload (temperature detection via encoder, I 2 t
monitoring)
Contact current EN 61800−5−1 > 3.5 mA AC, > 10 mA DC Observe the regulations
and safety instructions!
mains switching Cyclic mains switching of 5 times in 5 minutes is permissible
without restrictions.
Starting current £ 2 x I
rated
Discharge time of charge
stored after mains
disconnection typically 5 min
The duration is indicated by a warning symbol on the device.