Avaya X330WAN User Manual
Page 73
Policy
Avaya X330WAN User’s Guide
51
The following policy commands are performed within an Interface context:
To display the Policy configuration, use the following commands:
•
ip access-list-dscp
operation
Specifies the action to be mapped to a DSCP
value.
•
ip access-list-dscp trust
Configures the trusted entity.
•
ip access-list-dscp
precedence
Sets the DSCP precedence.
•
ip access-list-dscp name
Sets the DSCP name.
•
set qos policy-source
Sets the Policy source.
•
no ip composite-op
Deletes a composite operation from the
Composite Operations Table.
•
ip composite-op notify
Sets the trap mode of a composite operation in
a Policy list.
•
ip composite-op dscp
Sets the DSCP value of a Policy operation.
•
ip composite-op access
Sets the access value of a Policy operation.
•
ip composite-op priority
Sets the Layer 2 priority of a Policy operation.
•
ip composite-op name
Sets the name of a Policy operation.
•
[no] ip access-group
Activates a specific Policy list/suspends a
current Policy list.
•
ip simulate
Applies Policy to a simulated packet.
•
validate-group
Validates a Policy list.
•
show access-group
Displays information about configured access
groups.
•
show ip access-lists
Displays all Policy lists and their rules
(without any validation status).
•
show ip access-lists
details
Displays all Policy lists and their rules
(without any validation status), and displays
the DSCP table and the Composite Operation
Table.
•
show ip access-list-dscp
Displays the DSCP table of a given Policy list.
•
show ip access-list-
summary
Displays a summary of all Policy lists.