Avaya X330WAN - Manual (Page 202)

Chapter 6 X330WAN CLI Commands
180 Avaya X330WAN User’s Guide
ip ospf dead-interval (Interface context)
Use the ip ospf dead-interval command to configure the interval before
declaring the neighbor as dead. The no form of this command sets the
dead-interval to its default. The default is 40.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip ospf dead-interval
Parameters
Example
ip ospf dead-interval 15
ip ospf hello-interval (Interface Mode)
Use the ip ospf hello-interval command to specify the time interval between
hello packets the router sends. The no form of this command sets the hello-interval
to its default. The default is 10 seconds.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip ospf hello-interval
Parameters
Example
ip ospf hello-interval 5
seconds An integer from 1 to 415029.
seconds An integer from 1 to 65535.