Avaya X330WAN - Manual (Page 49)

Configuring the X330WAN
Avaya X330WAN User’s Guide 27
• v = VLAN number
Checking the Loopback, Fast Ethernet, E1/T1/USP, IP Interface Configuration
After configuring the new interface, you can perform the following tests to verify
that the new interface is operating correctly.
•
For the X330-2DS1, use the show controllers command to display the
status of the controller for E1/T1 interfaces.
• Use the show interfaces command to display
information on all interfaces: Fast Ethernet, FabricFast Ethernet, Serial, Console,
and Loopback. Verify that the output information is correct.
• Use the show frame-relay pvc [|]
command to display the Frame Relay interface configuration.
• Use the show ip interface [|
|] command to display IP interface
configured Serial and Ethernet ports.
• Use the show running-config command to display the configuration running
on the switch.
• Use the show startup-config command to display the configuration loaded
at startup.
• Use the ping [ []] command to send ICMP echo
request packets to another node on the network. Each node is periodically
pinged and checked if an answer was received. This checks host reachability
and network connectivity.
Table 3.2 X330W-2USP CLI Interface Contexts
CLI Interface Context PPP Frame Relay
Serial interface serial x interface serial x
Sub Frame Relay N/A interface serial x.z point-to-
point
IP interface serial x.w interface serial x.z.w
FastEthernet interface fastethernet 1.w interface fastethernet 1.w
FabricFastEthernet interface fabricfastethernet
1:v.w
interface fabricfastethernet
1:v.w