Avaya X330WAN - Manual (Page 209)

Layer 3 CLI Commands
Avaya X330WAN User’s Guide 187
ip routing-mode (Interface context)
Use the ip routing-mode command to set the IP routing mode of the interface.
The IP address used in Avaya MultiService Network Manager is the primary
management interface IP address. Only one interface can be in
RT_PRIMARY_MGMT mode. By default, the first IP address defined is used as the
primary interface.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
ip routing-mode
Parameters
Syntax
ip routing-mode
Example
X330WAN-2DS1-1(configure)# ip routing-mode RT_PRIMARY_MGMT
ip vrrp (Interface context)
Use the ip vrrp command to create a virtual router on the interface. The no form
of this command deletes a virtual router.
Note: This command is executed from the Fast Ethernet and FabricFastEthernet
interfaces.
Syntax
[no] ip vrrp
Parameters
Example
X330WAN-2DS1-1(configure)# ip vrrp 1
mode RT_PRIMARY_MGMT mode. In RT-MGMT mode, the interface functions
as a routing interface. In RT_PRIMARY_MGMT mode, the interface
functions as both a routing interface and a primary management interface.
vr-id Virtual Router ID, an integer from 1 to 255.