Avaya X330WAN - Manual (Page 174)

Chapter 6 X330WAN CLI Commands
152 Avaya X330WAN User’s Guide
Parameters
Example
X330W-2USP-1(super-if:Serial2)# keepalive 300
ppp timeout ncp (Serial interface context)
Use the ppp timeout ncp command to set the maximum time, in seconds, that the
PPP should allow for negotiation of a network layer protocol. The no form of this
command disables the maximum time that the PPP should allow for negotiation.
Syntax
[no] ppp timeout ncp
Parameters
Example
X330WAN-2DS1-1(config-if:Serial1:1)# ppp timeout ncp 10
ppp timeout retry (Serial interface context)
Use the ppp timeout retry command to set the maximum time, in seconds, to
wait for a response during PPP negotiation. The no form of this command restores
the maximum time to wait for a response during PPP negotiation to the default
value (2 seconds).
Syntax
[no] ppp timeout retry
Parameters
Example
X330WAN-2DS1-1(config-if:Serial1:1)# ppp timeout retry 10
Seconds The number of seconds between PPP keepalive messages (an integer
from 0 to 32767). Entering
keepalive without a parameter returns the
keepalive to its default of 10 seconds. Entering keepalive 0 disables
keepalive .
Seconds The maximum time, in seconds, PPP should allow for negotiation of a
network layer protocol. If no network protocol is negotiated within the
given time, the connection is terminated. An integer from 1 to 65535.
Seconds The maximum time, in seconds, to wait for a response during PPP
negotiation. An integer from 1 to 255.