Configuring the fabricfast ethernet interface – Avaya X330WAN User Manual

Page 43

Configuring the X330WAN

Avaya X330WAN User’s Guide

PMI is configured, the following message appears:

The primary management interface has changed.

For this change to take effect, you need to copy running-config

startup-config and then reset the device.

Enter the

copy running-config startup-config

and

reset

commands at this

stage.

Configuring the FabricFast Ethernet Interface

All CLI commands mentioned in this section are described in Chapter 6: X330WAN
CLI Commands.
To configure a FabricFast Ethernet interface:
1

Use the

interface FabricFastEthernet

command to enter the

FabricFast Ethernet interface context, where the if-number format is

port[:vlan[.ip-interface index]]

Note:

You do not need to include the ip-interface index if you configure only one IP

interface.

Use the

ip address

command to assign an IP address to the interface.

For example:

To configure the IP addresses 10.10.10.1 on VLAN 2 and 20.20.20.1

and 30.30.30.1 on VLAN 3 perform the following:

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:2

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# ip address

10.10.10.1 24

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# exit

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.1

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# ip address

20.20.20.1 24

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# exit

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.2

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# ip address

30.30.30.1 24

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# exit

Note:

The first IP interface created in the X330WAN automatically becomes the

PMI, described in detail on page 34. It is recommended to configure the Loopback
interface as the first Layer 2 interface and to configure an IP interface on it. After the
PMI is configured, the following message appears: