Avaya X330WAN - Manual (Page 173)

PPP Configuration CLI Commands
Avaya X330WAN User’s Guide 151
show map-class frame-relay
Use the show map-class frame-relay command to display the map-class Frame
Relay table.
Syntax
show map-class frame-relay
Example
X330WAN-2USP-1(super)# show map-class frame-relay
Showing 1 frame-relay map-class entry
Map Class Name CIR BC BE De Pre-Mark Fragment
--------------- --------- --------- --------- ----------- ---------
default 56000 7000 0 100% 0
PPP Configuration CLI Commands
This section contains a list of all PPP configuration related CLI commands.
ip tcp decompression-connections (PPP interfaces)
Use the ip tcp decompression-connections command to set the number of TCP
decompression connections. The no form of this command restores the default.
Syntax
[no] ip tcp decompression-connections []
Parameters
Example
X330WAN-2USP(super)# ip tcp decompression-connections 20
keepalive (Serial interface context PPP encapsulation)
Use the keepalive command to enable PPP keepalive. The no form of this
command disables PPP keepalive.
Syntax
[no] keepalive []
number The number of TCP decompression connections, an integer from 3-256.
The default is 16.