Avaya X330WAN - Manual (Page 207)

Layer 3 CLI Commands
Avaya X330WAN User’s Guide 185
ip rip send-receive (Interface context)
Use the ip rip send-receive command to set the RIP send and receive modes
on an interface. The default state is talk-listen. The no form of this command sets the
RIP to talk (i.e., send report).
Syntax
[no] ip rip send-receive-mode []
Parameters
Example
X330WAN-2DS1-1(super-if:Serial:1:1)# ip rip send-receive talk-listen
ip rip split-horizon (Interface context)
Use the ip rip split-horizon command to enable the split-horizon mechanism.
The no form of this command disables the split-horizon mechanism. By default
split-horizon is enabled.
The split-horizon mechanism prevents information about routes from exiting the
router interface through which the information was received. This prevents routing
loops.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip rip split-horizon
Example
X330WAN-2DS1-1(super-if:Serial:1:1)# no ip rip split-horizon
mode talk-listen - Sets RIP to receive and transmit updates on the
interface.
talkdefault-listen - Sets RIP to receive updates on the
interface and send only a default route.
listen-only - Sets RIP to receive updates on the interface and
not transmit them.
default route
metric
Integer value.