Avaya X330WAN - Manual (Page 142)

Chapter 6 X330WAN CLI Commands
120 Avaya X330WAN User’s Guide
description (Controller context)
Use the description command to set the description of the E1/T1 interface. This
description appears both in the ifAlias and the circuitIdentifier MIB values
for that interface. The no form of this command removes the controller’s
description.
Note: This command can also be executed from the Serial, Loopback, Fast Ethernet,
and FabricFastEthernet interfaces.
Syntax
[no] description
Parameters
Example
X330WAN-2DS1-1(config-controller:1)# description "E1 controller"
X330WAN-2DS1-1(config-controller:1)# no description
fdl
Use the fdl command to define an FDL type. FDL is used to define a remote
loopback for the module or to receive the far-end counters.
The no form of this command disables the FDL.
Note:
1. This command can only be performed if the controller is set to T1.
2. Use this command only when ESF framing is defined.
Syntax
[no] fdl
Parameters
Example
X330WAN-2DS1-1(configure)# fdl ansi
desc A string describing the E1/T1 interface. The string may contain blanks
and can be up to 255 characters long.
fdl-mode ansi | att | both