Avaya X330WAN - Manual (Page 232)

Chapter 6 X330WAN CLI Commands
210 Avaya X330WAN User’s Guide
Syntax
[no] ip access-group
Parameters
Example
X330WAN-2DS1-1(config-if:FastEthernet1)# ip access-group 110 out
ip access-list
Use the ip access-list command to create a specific Policy rule. Each rule
pertains to the source IP address, the destination IP address, the protocol, the
protocol ports (TCP/UDP, if relevant), and to the ACK bit (in TCP protocol). The
no
form of this command deletes a specific rule.
The syntax for this command is:
[no] ip access-list
{ |any|host }
[ [
wildcard>|any|host }[
[]][established] [precedence]
Parameters
policy-list-number An integer from 100 to 149, where 0 is the default list.
direction in|out
policy-list-number An integer from 100 to 149.
access-list-index An integer from 100 to 149.
action permit|deny|deny-and-notify|fwd0-7| composite
op name
protocol ip|tcp|udp| integer from 1 to 255.
source-ip IP network
source-wildcard IP network wildcard
operator eq|lt|gt|range
port An integer from 1 to 65535.
destination-ip IP network
destination-wildcard IP network wildcard