Avaya X330WAN - Manual (Page 133)

Console (RS232) Interface CLI Commands
Avaya X330WAN User’s Guide 111
interface Console
Use the interface Console command to enter the Console interface ( interface
console context) to PPP configure mode. For LAN interfaces, use this command to
create the interface. The no form of this command sets the default Console
parameters.
Syntax
[no] interface Console
Example
X330WAN-2DS1-1(configure)# interface Console
ppp authentication (Console interface context)
Use the ppp authentication command to set the type of password that should be
sent for authentication, if necessary.
Syntax
ppp authentication {pap|chap|none}
Parameters
Example
To select the CHAP authentication protocol:
X330WAN-2DS1-1(config-if:CON)# ppp authentication chap
speed (Console context)
Use the speed command to set the PPP baud rate to be used by asynchronous PPP
ports.
Note:
1. This command is executed from the Console interface.
2. The peer baud-rate must be set to the same value.
Syntax
speed {9600|19200|38400}
pap Password Authentic Protocol. Unencrypted password sent for authentication.
chap Challenge Handshake Authentication Protocol. Encrypted password sent for
authentication.
none No password sent.