Avaya X330WAN - Manual (Page 109)

Avaya X330WAN User’s Guide 87
Chapter 6
X330WAN CLI Commands
This chapter provides a complete list of all X330WAN module-related CLI
commands. Each command that appears on the list is accompanied by a detailed
description, including the proper syntax. The list is presented in alphabetical order
to help you locate commands easily.
Introduction: About the CLI
The CLI is command-line driven and does not have any menus. To activate a
configuration option, type the desired command at the prompt and press Enter.
To configure the X330WAN, you must either be in supervisor mode, or enter the
configure context. Generic commands are performed from the configure context.
If you are in supervisor mode or have entered the configure context, you can enter
any of the following contexts:
•
Controller (X330W-2DS1 only)
• Interface Console
• Interface Fast Ethernet
• Interface FabricFastEthernet
• Interface Serial
• Interface Loopback
• Other contexts
Layer 1 (E1/T1) commands are performed from the controller context, and
Layer 2/Layer 3 (Fabric, PPP, Frame Relay, Fast Ethernet, IP) commands are
performed from the various Interface contexts.
To exit a context, type
exit .
You can use all show commands in user mode.
For a list of all Controller commands, see "Controller CLI Commands (X330WAN-
2DS1 Only)" on page 115.
For a list of all Interface Fast Ethernet commands, see "Fast Ethernet Interface CLI
Commands" on page 112.
For a list of all Interface FabricFastEthernet commands, see "FabricFast Ethernet
Interface CLI Commands" on page 114.
For a list of all Interface Loopback commands, see "Loopback CLI Commands" on
page 153.