Avaya X330WAN - Manual (Page 151)

Interface Serial CLI Commands
Avaya X330WAN User’s Guide 129
show controllers remote
Use the show controllers remote command to display far end performance data
through an FDL message.
Note: This command is used when the fdl at&t option is defined.
Syntax
show controllers remote
Parameters
Example
X330WAN-2DS1-1(super)# show controllers remote 1 1h-data
shutdown (Controller context)
Use the shutdown command to shutdown the E1/T1 link. This has the effect of
administratively bringing the line down. In effect, it sends a 'blue alarm' on the line.
The
no form of this command reconnects the E1/T1 link.
Syntax
[no] shutdown
Interface Serial CLI Commands
This section contains a list of all Interface Serial related CLI commands.
backup delay (Serial interface context)
Use the backup delay command to set the switchover delay in case of failure.
Syntax
backup delay
port The number of the port.
fdl-request- type Request types include:
• 1h-data.
• Enhanced-CI-configuration.
• Enhanced-1h.
• Errored-ESF-data.