Avaya X330WAN - Manual (Page 190)

Chapter 6 X330WAN CLI Commands
168 Avaya X330WAN User’s Guide
Parameters
Example
X330WAN-2DS1-1(configure router:rip)# distribution-list 10 in
"FabricFastEthernet 1"
X330WAN-2DS1-1(configure router:rip)# distribution-list 20 out
"Serial 1:1"
X330WAN-2DS1-1(configure router:rip)# distribution-list 40 out ospf
fragment chain
Use the fragment chain command to set the maximum number of fragments that
can comprise a single IP packet destined to the router. The no form of this command
sets the fragment chain to the default value (64).
Note: No IP reassembly is performed on packets in transit through the router.
Syntax
[no] fragment chain
Parameters
Example
X330WAN-2DS1-1(configure)# fragment chain 30
access-list-number An integer from 1 to 99.
type [in | out]
interface-type The interface type, a string.
interface-number The interface number.
protocol [static | ospf]
Protocol is only relevant for outgoing (out) list entries.
chain-limit The maximum number of fragments that can comprise a single IP
packet, from 2 to2048. The default is 64.