Avaya X330WAN - Manual (Page 34)

Chapter 2 Installation
12 Avaya X330WAN User’s Guide
X330W-2DS1 Front Panel and LEDs
The front panel of the X330W-2DS1 has two columns of four LEDs each, one for
each Serial (WAN) port in the access router module. There is also a Fast Ethernet
port, and a Console port for directly connecting a terminal. Between the LEDs and
the Console port there is a RST/FIV button for manually resetting the module.
Figure 2.1 X330W-2DS1 Front Panel
Table 2.1 describes the LEDs on the front panel of the X330W-2DS1.
Table 2.1
X330W-2DS1 LED Descriptions
LED Name Color Description LED Status
ALM Red Alarm
ON - Module is initializing, or
when an alarm state exists on an
interface.
OFF - Initialization successful,
module software functioning
properly, no alarm conditions on
an interface.
TST Green Test
ON - Port is being initialized or
loopback is active.
OFF - Port initialization completed
and loopback is not active.
ACT Yellow Active
ON - At least one PPP/Frame
Relay session is active.
OFF - No active PPP/Frame Relay
session.
SIG Green Signal
ON - A signal is detected on the
port.
OFF - No signal is detected on the
port.