Festo Кабели и принадлежности User Manual
Spc200 smart positioning controller
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Designated use
- Target group
- Service
- Important user instructions
- Product-specific terms and abbreviations
- Notes on the use of this manual
- Firmware versions of the field bus modules PROFIBUS-DP
- System summary
- Fitting
- Installation
- Commissioning
- Contents
- 4.1 Procedure for commissioning
- 4.2 Setting the PROFIBUS address of the SPC200
- 4.3 Installing the device master file (GSD file) and symbol files
- 4.4 Basic principles of configuration
- 4.4.1 FREEZE and SYNC
- 4.4.2 Configuration of the I/O address range
- 4.4.3 DP identifiers for the I/O signals
- 4.4.4 DP identifiers for the parameter channel (optional)
- 4.4.5 DP identifiers for transmitting the actual postions (optional)
- 4.4.6 DP identifier for transmission of the setpoint positions (optional)
- 4.5 Configuration with a master
- 4.6 Commissioning on the field bus
- 4.7 Sequence plans for the programmer
- Parameter channel
- Diagnosis and error treatment
- Technical appendix
- Index