Festo Кабели и принадлежности - Manual (Page 91)

4. Commissioning
4−45
Festo P.BE−SPC200−COM−PDP−E N en 0901c
The following signals must be present at the controller inputs
before the readiness to operate can be created:
Record Select mode
Controller input Signal
ENABLE 0−signal 1)
STOP 0−signal
RESET 0−signal
CLK_B Not relevant
CLK_A Not relevant
1) Observe the instructions on enabling the controller in section 4.1.
Start/Stop mode
Controller input Signal
ENABLE 0−signal 1)
STOP 0−signal
START/RESET 0−signal
SYNC_IB Not relevant
SYNC_IA Not relevant
1) Observe the instructions on enabling the controller in section 4.1.