Festo Кабели и принадлежности - Manual (Page 71)

4. Commissioning
4−25
Festo P.BE−SPC200−COM−PDP−E N en 0901c
Configuring the Slave properties
After clicking the symbol for the SPC200, you can configure
the Slave properties" in the lower part of the screen. Here
you can determine the number and size of the I/O ranges of
the slave and assign them with address ranges of the master.
In order to configure the Slave properties of the SPC200:
1. open the permitted identifiers in the hardware catalogue
under Festo SPC200
2. then use the mouse to pull the desired identifier into the
appropriate line under Module/DP identifier.
When configuring the I/O address range, observe the rules in
section 4.4.2.