Festo Кабели и принадлежности - Manual (Page 85)

4. Commissioning
4−39
Festo P.BE−SPC200−COM−PDP−E N en 0901c
Byte Bit 0
Bit 8 Bit 1
Bit 9 Bit 2
Bit 10 Bit 3
Bit 11 Bit 4
Bit 12 Bit 5
Bit 13 Bit 6
Bit 14 Bit 7
Bit 15
n+6
n+7 Q13.7
Q13.15 Q13.6
Q13.14 Q13.5
Q13.13 Q13.4
Q13.12 Q13.3
Q13.11 Q13.2
Q13.10 Q13.1
Q13.9 Q13.0
Q13.8
1) Address assignment from the point of view of the SPC200
4.6.2 Internal I/O addresses with Record Selection mode
The configured outputs of the master are mapped on the
input bits (I10.0...I11.15).
Byte Bit 7
Bit 15 Bit 6
Bit 14 Bit 5
Bit 13 Bit 4
Bit 12 Bit 3
Bit 11 Bit 2
Bit 10 Bit 1
Bit 9 Bit 0
Bit 8
Input bits (I10.0...I11.15) 1)
n
n + 1 Ĉ
Ĉ Ĉ
Ĉ Ĉ
Ĉ CLK_B
Ĉ CLK_A
Ĉ STOP
Ĉ RESET
Ĉ ENABLE
Ĉ
n+2
n+3 RECBIT...
Record number from 0 to 999, output word (2 byte, MSB−LSB)
1) Address assignment from the point of view of the SPC200
The internal outputs of the field bus module are mapped on
the configured inputs of the master.
Byte Bit 7
Bit 15 Bit 6
Bit 14 Bit 5
Bit 13 Bit 4
Bit 12 Bit 3
Bit 11 Bit 2
Bit 10 Bit 1
Bit 9 Bit 0
Bit 8
Output bits (Q10.0...Q13.15) 1)
n
n + 1 Ĉ
Ĉ Ĉ
Ĉ Ĉ
Ĉ RC_B
Ĉ RC_A
Ĉ ACK_B
Ĉ ACK_A
Ĉ Ready
Ĉ
1) Address assignment from the point of view of the SPC200