Festo Кабели и принадлежности - Manual (Page 68)

4. Commissioning
4−22
Festo P.BE−SPC200−COM−PDP−E N en 0901c
4.5 Configuration with a master
The following chapter describes the configuration of the
SPC200 as a PROFIBUS slave especially with a Siemens DP
master. The configuration in general for PROFIBUS masters of
other manufacturers is then described.
Various configuration programs are available for Siemens DP
masters. This manual refers to STEP 7 V5.1 (hardware confiĆ
gurator).
Configuration programs are subject to updates which may
not yet be taken into consideration in this manual. Inform
yourself in this case with the aid of the appropriate product
documentation.