Festo Кабели и принадлежности - Manual (Page 96)

4. Commissioning
4−50
Festo P.BE−SPC200−COM−PDP−E N en 0901c
4.7.3 Start program or NC record
Prerequisites
Ĉ The program must be in the program memory
Ĉ The axis, application and system data must be set correctly
Ĉ The operating mode must be set
Ĉ Readiness of the SPC200 to operate has been created (1−signal at
the ENABLE and STOP inputs and at the READY output)
Start NC program in Start/Stop mode
In the Start/Stop operating mode, the sequence is started or
continued with a rising edge at the START input. In this case
there must be a 1−signal at the STOP input.
If there is a 0−signal at the STOP input, a program reset will be
triggered by a rising edge at the START input.
Set START
Reset START
Wait 10 ms
Process NC program in
Start/Stop mode
Prepare new start
NC program is started
Debouncing time
End
Fig. 4/19: Start NC program in Start/Stop mode