Festo Кабели и принадлежности - Manual (Page 30)

1. System summary
1−12
Festo P.BE−SPC200−COM−PDP−E N en 0901c
Address range
If a field bus module is used:
ć The address ranges I0.0 ... I0.9 and Q0.0 ... Q0.7 will reĆ
main unassigned. This address range, which without field
bus module serves for controlling the SPC200, is not
available.
ć The address ranges I10.0 ... I13.15 and Q10.0 ... Q13.15
are only available in I/O operation.
ć Maximum 3 I/O modules may be plugged in. These proĆ
vide only freely programmable I/Os in the operating mode
Start/Stop.
The following table shows the address assignment when a
field bus module is used.
Module Max. address range
Ĉ 1) I0.0 ...I0.9 1) Q0.0 ... Q0.7 1)
I/O module on the first axis interface string I1.0 ... I1.15 Q1.0 ... Q1.15
First I/O module I2.0 ... I2.9 Q2.0 ... Q2.7
I/O module on the second axis interface string I3.0 ... I3.15 Q3.0 ... Q3.15
Second I/O module I4.0 ... I4.9 Q4.0 ... Q4.7
Third I/O module I5.0 ... I5.9 Q5.0 ... Q5.7
Field bus module I10.0 ... I13.15 Q10.0 ... Q13.15
1) Address range is not available if a field bus module is used.
The functions of the internal input and output bits of the field
bus module as well as the permitted NC commands depend
on the operating mode set. Detailed information on this can
be found in the System manual for the SPC200.