Festo Кабели и принадлежности - Manual (Page 98)

4. Commissioning
4−52
Festo P.BE−SPC200−COM−PDP−E N en 0901c
Record Select mode
Controller input Signal
ENABLE 1−signal
STOP When quitting with the RESET signal: 0−signal
When quitting with the CLK signal: 1−signal
RESET 0−signal
CLK_B 0−signal
CLK_A 0−signal
Fig. 4/20: Signal states required in Record Select mode
Start/Stop mode
Controller input Signal
ENABLE 1−signal
STOP 1−signal *)
START/RESET 0−signal
SYNC_IB Not relevant
SYNC_IA Not relevant
*) If there is a 0−signal at the STOP input, a program reset will be
triggered by a rising edge at the START/RESET input.
Fig. 4/21: Signal states required in the Start/Stop mode