Festo Кабели и принадлежности - Manual (Page 118)

5. Parameter channel
5−18
Festo P.BE−SPC200−COM−PDP−E N en 0901c
PNU 213
d
(D5
h
): Created NC program
Description Number of the created NC program (NC program is active or ready to start)
Permitted values 0...99
Presetting 0
Data type Unsigned16
Unit Ĉ
Subindices 1: Applied program in task A
2: Applied program in task B
Access rights Read: yes; write: under condition 1)
Task identifier 6, 7, 8, 9
Reply identifier
(positive) 4, 5, 6
Protected against
power failure No
1) Writing is only permitted if:
Ĉ the SPC200 has stopped and there is a 1−signal at the ENABLE input (otherwise a write task will
trigger fault number 17 (see also section 5.2.1).
Ĉ a starting program has been configured for the relevant task.
Ĉ different programs have been created for the two tasks.