6 commissioning on the field bus, Commissioning on the field bus – Festo Кабели и принадлежности User Manual
Page 83
4. Commissioning
4−37
Festo P.BE−SPC200−COM−PDP−E N en 0901c
4.6
Commissioning on the field bus
Please note
Please observe also the instructions in the manual for your
controller.
Commissioning software for the field bus master usually proĆ
vides an online operating mode. In this online mode you can
influence the current states of the field bus inputs and outĆ
puts.
As with commissioning with WinPISA, you can also generate
the control signals of the SPC200 via the PROFIBUS master.
By means of the online operating mode of the software for
the PROFIBUS master, you can test the functioning of the
SPC200 on the field bus.
The following tables give an overview of the configurable field
bus address range of the field bus module. Address assignĆ
ment from the point of view of the SPC200.
Please note
Outputs of the master are mapped on internal inputs;
internal outputs of the field bus module are mapped on
inputs of the master.