Festo Кабели и принадлежности - Manual (Page 51)

4. Commissioning
4−5
Festo P.BE−SPC200−COM−PDP−E N en 0901c
In order to generate control signals in the test mode, first
activate the command [Online]Ă[Observe]Ă[Field bus modĆ
ule]Ă[Control signals/Record number]. Then switch on the test
mode, e.g. with function key F5.
The contents of the window [Control signals] depends on the
operating mode set. The mark
? next to the control signal
shows that the relevant input/output supplies a 1−signal.
1
ENABLE signal
2
STOP signal
3
Display for test
mode
1
2
3
Fig. 4/1: Control signals for commissioning (example)
The signals ENABLE and STOP are important for commisĆ
sioning.
Now refer to the WinPISA manual for carrying out commisĆ
sioning.
I/O control signals (overview)
A detailed explanation of the I/O control signals can be found
in the System manual for the SPC200. The tables below give a
brief overview: