Festo Кабели и принадлежности - Manual (Page 35)

2. Fitting
2−5
Festo P.BE−SPC200−COM−PDP−E N en 0901c
Fitting a module
Proceed as follows when fitting a module into the rack:
1. Switch off the compressed air supply and the operating
voltage supply.
2. Remove the blanking plate (if fitted).
3. Hold the module by the front plate and push it into the
guide rail. Make sure that the modules are not tilted when
they are pushed in and that no components on the
printed circuit board are damaged.
4. Make sure that the plugs of the terminal strips are corĆ
rectly aligned. Then gently push the module in as far as
possible. The locking levers will then lock automatically.
1
Direction for
unlocking
2
Locks
automatically
3
Locking lever
4
Front plate of the
module
5
Terminal strip
6
Guide rail
1
2
3
4
2
1
5 6
Fig. 2/1: Fitting a module