HP XP7 Storage - Manual (Page 277)

Table 88 SSB codes that are returned by raidcom modify rcu command (continued)
raidcom modify rcu
Description Error code Executing/
Async Error message
SSB2 SSB1
The attribute of the RCU cannot be changed because the
specified RCU is not registered. 3001 2E20 Executing CMDRJE
The specified CU number is not defined, or an LDEV is not
defined under the CU number. 7101 2E21 Async Get Command Status
The operation cannot be done because the number of paths
becomes less than the least path number. 3101 2E23 Executing CMDRJE
Command cannot be executed because the RCU identification
code of a path is invalid. 3001 2E31 Async Get Command Status
An internal error occurred. 00EF 2ED6 Executing CMDRJE
Call HP Technical Support.
The value of SSID for the remote storage system is invalid. 3300 2ED6 Executing CMDRJE
Table 89 SSB codes that are returned by raidcom delete rcu_path command
raidcom delete rcu_path
Description Error code Executing/
Async Error message
SSB2 SSB1
The CU# of RCU exceeds the effective value. 3001 2E00 Executing CMDRJE
The product ID or the path registration ID is invalid. 3005 2E00 Executing CMDRJE
Command cannot be executed because the parameter of
specified RCU is invalid. 3008 2E00 Async Get Command Status
The specified port # on the side of RCU is invalid. 3200 2E00 Executing CMDRJE
The CU number is out of effective range. 7100 2E00 Executing/
Async CMDRJE
Get Command Status
The value of specified port is invalid. 8400 2E00 Executing CMDRJE
/Async Get Command Status
Failed to establish a path or the deletion operation. The following
factor can be thought. 3101 2E10 Async Get Command Status
•
Input parameter is invalid.
• Port status or the MP Blade status is in the state of abnormal.
•
Cable is not connected correctly.
• Port is specified incorrectly.
The operation cannot be done because the microcode is being
changed. 8004 2E11 Async Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
A logical path cannot be deleted because the specified RCU is
not registered. 3001 2E20 Async Get Command Status
The specified CU number is not defined, or an LDEV is not
defined under the CU number. 7101 2E21 Async Get Command Status
Error messages and error codes 277