HP XP7 Storage - Manual (Page 258)

Table 78 SSB codes that are returned by raidcom rename pool command (continued)
raidcom rename pool
Description Error code Executing/
Async Error message
SSB2 SSB1
The pool name is duplicated with another pool. 6001 2E31 Executing CMDRJE
An internal error occurred. FEEC 2EE7 Executing CMDRJE
Call HP Technical Support.
Table 79 SSB codes that are returned by raidcom delete pool command
raidcom delete pool
Description Error code Executing/
Async Error message
SSB2 SSB1
LDEV# exceeds the range. 0000 2E00 Executing CMDRJE
The value of pool ID is out of range. 6000 2E00 Executing CMDRJE
All pool volumes associated to a pool cannot be deleted. 600B 2E00 Async Get Command Status
The specified LDEV is in the state of blocked. 0009 2E10 Async Get Command Status
This pool cannot be deleted because a volume in the pool is
being deleted. 600D 2E10 Executing CMDRJE
The operation cannot be done because the pool usage rate
exceed the threshold value of the pool usage. 600E 2E10 Async Get Command Status
The operation cannot be done because the current capacity rate
exceeds the value of maximum reserved capacity rate. 600F 2E10 Async Get Command Status
It cannot be deleted because the pool volume is set in the state
of being deterred deleting. 6010 2E10 Async Get Command Status
Deleting operation cannot be done because it is being discarded
pages. 6011 2E10 Async Get Command Status
The specified operation is not supported in the current microcode
version. 8002 2E10 Async Get Command Status
The operation cannot be done because a Fast Snap or Snapshot
pair remains or the association with a Thin Provisioning virtual
volume exists. 001F 2E11 Async Get Command Status
The operation cannot be done because a Fast Snap or Snapshot
pair is being deleted or a Thin Provisioning virtual volume is
being deleted. 0020 2E11 Async Get Command Status
The operation cannot be done because a pool volume of a
specified pool is being formatted. 0021 2E11 Async Get Command Status
The pool is not in the status where the pool can be deleted or
a pool volume can be deleted. 6003 2E11 Executing/
Async
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off. 8003 2E11 Async Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified LDEV is not registered to the pool. 0003 2E20 Executing CMDRJE
The operation cannot be done because the pool volume is not
of a specified pool. 0003 2E20 Async Get Command Status
258 Troubleshooting