HP XP7 Storage - Manual (Page 259)

Table 79 SSB codes that are returned by raidcom delete pool command (continued)
raidcom delete pool
Description Error code Executing/
Async Error message
SSB2 SSB1
Pool ID is not installed. 6000 2E20 Executing/Async CMDRJE
Get Command Status
The operation cannot be performed because the shared memory
(SM) is not initialized. 8106 2E21 Async Get Command Status
The number of specified LDEVs is invalid. 0008 2E23 Executing CMDRJE
The specified LDEV cannot be deleted because it is a top VOL
of the pool. 0052 2E30 Executing CMDRJE
The specified pool is a pool for Fast Snap or Snapshot. 6003 2E30 Executing CMDRJE
The command cannot be accepted. After a while, execute the
same command. 00EE 2EE7 Executing CMDRJE
Pool ID is not installed. 00F9 2EE7 Executing CMDRJE
An internal error occurred. FEEC 2EE7 Executing CMDRJE
Call HP Technical Support.
The specified parameter is invalid. Check the HP XP7 RAID
Manager Reference Guide. 6002 2EF3 Executing CMDRJE
Table 80 SSB codes that are returned by raidcom add snap_pool command
raidcom add snap_pool
Description Error code Executing/
Async Error message
SSB2 SSB1
The value of LDEV number is out of range. 0000 2E00 Async Get Command Status
Pool ID is out of range. 6000 2E00 Executing CMDRJE
The type of pool is invalid. 6001 2E00 Executing CMDRJE
The maximum reserve ratio for V-VOL is out of range. 6002 2E00 Executing CMDRJE
The operation cannot be done because a SATA-E drive in the
state of quick formatting is in the specified LDEV. 000C 2E10 Async Get Command Status
The specified LDEV is in the state of blocked. 0009 2E10 Async Get Command Status
The specified LDEV is in the state of blocked, or not installed. 0011 2E10 Executing CMDRJE
Fast Snap cannot be used because there are not enough cache
management devices to create pairs. 0050 2E10 Async Get Command Status
The pool cannot be created because there are not enough
resources (VDEV) depending on cache management devices. 0102 2E10 Async Get Command Status
The operation cannot be performed because the pool volume
is being deleted. 600D 2E10 Async Get Command Status
The pool is not in the status where the pool volume can be
added. 6003 2E11 Executing
/Async
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off. 8003 2E11 Async Get Command Status
Error messages and error codes 259