HP XP7 Storage - Manual (Page 265)

Table 81 SSB codes returned by raidcom add snapshot (continued)
raidcom add snapshot
Description Error code Executing/Async Error message
SSB2 SSB1
A Fast Snap pair specifying CTG mode cannot be created
because the maximum number of consistency groups has
already been defined. 2302 2E10 Executing CMDRJE
A Fast Snap or Snapshot pair cannot be created due to
unavailable of the pool. 6018 2E10 Executing CMDRJE
A Fast Snap or Snapshot pair cannot be created because
there are not enough pair tables. 8100 2E10 Executing CMDRJE
A Fast Snap or Snapshot pair cannot be created because
there are not enough differential tables. 8101 2E10 Executing CMDRJE
A pair cannot be created because there is not enough free
shared memory space. 8102 2E10 Executing CMDRJE
The command ends abnormally because the pair is in the
state of unacceptable the command. 9701 2E10 Executing CMDRJE
A Fast Snap or Snapshot pair cannot be created because
the number of Fast Snap or Snapshot pairs has already
reached the maximum. 9705 2E10 Executing CMDRJE
A Fast Snap pair cannot be created because the maximum
number of Snapshot IDs (MU numbers) has already been
in use for the specified P-VOL. 9706 2E10 Executing CMDRJE
A Fast Snap pair cannot be created because the maximum
number of Snapshot groups has already been defined, or 9707 2E10 Executing CMDRJE
the maximum number of Fast Snap pairs has already been
defined in the specified Snapshot group.
A Fast Snap pair cannot be created because the DP pool
is being initialized. 9708 2E10 Executing CMDRJE
An error occurred at the operation of Fast Snap due to one
of the following reasons: 9800 2E10 Executing CMDRJE
•
The LDEV number specified for the P-VOL or the S-VOL
is incorrect.
• The LDEV specified as the P-VOL or the S-VOL is not
paired.
•
The pair of the specified P-VOL or the S-VOL is not ready
to perform the specified operation.
• The specified Snapshot ID (MU number) is wrong.
•
The specified Snapshot ID (MU number) is already used.
• The specified pool is not in the usable status.
•
The license capacity has exceeded the maximum.
•
The control table for Fast Snap is depleted.
The operation cannot be performed because power-off is
in progress. 8003 2E11 Executing CMDRJE
A Fast Snap or Snapshot pair cannot be created because
the specified P-VOL is a LUSE volume. 0000 2E13 Executing CMDRJE
A pair cannot be created because there is a pair in the
specified primary volume, which is using a different pool
number from the specified pool number. 6003 2E13 Executing CMDRJE
Error messages and error codes 265